Sony SPP-AQ600 Manual De Instrucciones página 42

Resetting the digital security
code
Since a random security code is automatically assigned between the
base phone and the handset when you charge the battery pack for (he
first time, you normally do not need to reset the security code.
However, in the unlikely event that you suspect that another cordless
phone uses the same security code, you can manually change the
code as follows:
RING ON/
1
2
3
Replace the handset on the base phone.
Press ClNTERCOM).
Lift the handset for more than one second.
Then replace the handset on the base phone
and keep it for more than three seconds to
complete the code change.
Notes
* Make sure that the RING ON/BATT SAVE
switch is set to RING ON.
• If the battery pack in the handset is
completely discharged, or is removed from
the handset for more than several seconds,
the digital security code stored will be lost.
If this happens, charge the battery pack,
and a new security code will be
automatically assigned.
Tip
This procedure will change the code in both
the base phone and the handset. The code can
be changed as often as desired.
42™
Additional Information