Publicidad
Idiomas disponibles
Idiomas disponibles
The Cooking Mode
Indicator comes on,
but heating does not
start.
Heating stops suddenly
during operation and the
display flashes "u".
Heating zones of the same
side ( Such as the first and
the second zone ) would
display "u" .
Fan motor
sounds abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to
the induction hob.
9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing. For the purpose of
installation and use, a minimum of 5 cm space shall be preserved around the hole. Be sure
the thickness of the work surface is at least 30mm. Please select heat-resistant and
insulated work surface material (Wood and similar fibrous or hygroscopic material shall not
be used as work surface material unless impregnated) to avoid the electrical shock and
larger deformation caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces
of the worktop should be at least 3mm.
High temperature of
the hob.
There is something
wrong with the
fan.
The power board is
damaged.
Pan Type is wrong.
Pot diameter is
too small.
Cooker has overheated;
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
20
Ambient temperature
may be too high. Air
Intake or Air Vent may
be blocked.
Check whether the fan
runs
smoothly；
if not , replace the fan.
Replace the power board.
Use the proper pot (refer
to the instruction
manual.)
Unit is overheated. Wait
for temperature to return
to normal.
Push "ON/OFF" button to
restart unit.
Check the connection.
Replace the
display board.
Replace the power board.
Replace the fan.
Pan detection
circuit is damaged,
replace the power
board.
V.1
Publicidad
