Publicidad
Idiomas disponibles
Idiomas disponibles
3.3 How to use
3.3.1 Start cooking
Touch the ON/OFF control for three seconds. After
power on, the buzzer beeps once, all displays show "–"
or "– –", indicating that the induction hob has entered
the state of standby mode.
Place a suitable pan on the cooking zone that you
wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
Select a heat setting by touching the "-" or "+" control.
• If you don't choose a heat setting within 1
minute, the Induction hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any time
during cooking.
If the display flashes
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 2 minutes if no suitable pan is placed on it.
3.3.2 Finish cooking
Turn the cooking zone off by scrolling down to
"0" or touching "-" and "+" control together.
Make sure the display shows "0".
Turn the whole cooktop off by touching
the ON/OFF control.
alternately with the heat setting
11
V.1
Publicidad
