Franke FMY DRIP-FREE 60 Manual De Uso página 10

formation on how to re-cycle
this product, please contact
your local municipal offices,
local waste disposal service
or the shop in which the
product was purchased.
2. USE
• The suction hood has been designed
exclusively for domestic use, to elim-
inate kitchen odours.
• Never use the hood for purposes
other than those for which it was de-
signed.
• Never leave high flames under the
hood when it is in operation.
• Adjust the intensity of the flame so
that it is directed onto the bottom of
the cooking pan, making sure it does
not wrap around the sides.
• Deep-fryers must be kept under con-
stant supervision when in use: the oil
may catch fire if it gets too hot.
• The ZERO DRIP SYSTEM offers the
best performance when the hood is
used at maximum suction power
(third speed with hood in suction
mode, Intensive speed with hood in
filtering mode, see CONTROLS para-
graph).
• It is advisable to leave the hood on for
a few minutes after the end of cook-
ing.
• It is advisable not to remove the
grease filters as soon as cooking is
finished to allow time for any con-
densate that has collected in the
grease filter to settle in the tray.
• Always open the flap as far as it will
go.
• If the hood is installed in filtering
mode, it is advisable to carry out the
following procedure: by holding but-
ton B pressed for approximately two
seconds, when all the loads are off
(motor+lights), the activated carbon
filters alarm is activated and the In-
tensive speed is no longer timed to 6
10
minutes but has an infinite duration
(like the other speeds).
3. CLEANING AND
MAINTENANCE
• For maintenance of the activated car-
bon filter, refer to the instruction sheet
inside the kit.
• The grease filters must be cleaned
every 2 months of operation or more
frequently in case of very intense use
and can be washed in a dishwasher
(Z).
• When washing in the dishwasher, the
metal mesh of the grease filter may
darken but its filtering characteristics
do not change.
• Be careful not to compress the metal
filters.
• Clean the hood using a damp cloth
and a neutral liquid detergent.
• For external and internal cleaning of
the hood avoid alcoholic or silicone
products.
If the product or one of its parts is made
of stainless steel, use specific non-ab-
rasive products for cleaning and follow
the lines of the satin finish during clean-
ing.
Maintenance of the condensate tray
• The tray should be emptied and
cleaned AT LEAST once a week or
more frequently depending on the
use of the hood.