cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 100

ENGLISH
- The use of hose extensions is not recommended; if absolutely necessary, the extension
should have the same diameter as the original hose and should not exceed 250 cm in length
(Fig. 12).
- If drain hose is too long, do not force it into washing machine as it will cause abnormal
noises.
- After installation, wait a few hours before operating the appliance to allow it to acclimatise
to the ambient conditions in the room.
- Only connect the device when the installation has been completed.
4. OPERATION
Note
Before washing the clothes for the first time, the product shall be operated in one round of the
whole procedures without the clothes inside.
Control panel
A: Wash cycle knob
- Used to programme the desired wash cycle.
- OFF position
is on, the machine will stop running and turn off. If the machine is switched off during a wash
cycle, the wash cycle will be cancelled.
B: TEMP (Temperature)
Press the button to change the water temperature of the selected cycle, the temperature value
will appear on the display.
C: SPEED
Press the button to change the spin speed of the selected cycle, the speed value will appear
on the display.
CHILD LOCK FUNCTION
When a wash cycle is running, if you want to activate the child lock, press, and hold the SPEED
button for about 3 seconds.
Sound cancellation (buzzer)
- Press and hold the SPEED button and the ONE SMART button
least 3 seconds.
- You can cancel the sound during a wash cycle.
- Perform the same operation to restore the sound.
100
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A
: turn the wash cycle knob, when the indicator light below the symbol
at the same time for at