cecotec BOLERO DRESSCODE 8800 INVERTER A Manual De Instrucciones página 118

ENGLISH
Machine does not drain,
drains slowly or "E03"
appears on the display
The wash programme
time stops counting before
entering the high-speed
spin process
Washing programme lasts
too long
Excessive noise
The machine is
continuously filled with
water and continuously
emptied
The drained water returns
to the apparatus
Control panel gets hot
General issues
118
BOLERO DRESSCODE 8800 INVERTER A / INVERTER STEEL A / INVERTER ICE BLUE A
The top of the drain hose is too high. It should be installed at
a height of 65-100 cm from the ground.
The draining pump filter is blocked.
Drain hose is kinked or bent.
Drain hose is blocked or frozen.
This is not an issue. The load balancing system of the
appliance tumbles and scatters the laundry in the drum
for a long time to achieve balance and complete the high
speed spin. In the process of tumbling and scattering, the
programme time stops counting before the appliance reaches
the high-speed spin process.
Programme times will vary due to water pressure, incoming
water, temperature, etc.
If the wash load becomes unbalanced, the time will increase.
There will always be some noise from the motor, pump, and
drum during spinning.
The washing machine touches other objects.
Foreign objects, such as hairpins or metal objects, fall into the
drum.
The top of the drain hose is too low. It should be installed at a
height of 65-100 cm from the ground.
The end of the drain hose has been pushed too far down into
the standpipe; the hose elbow must be installed 100 mm
from the end of the drain hose.
The end of the drain hose is submerged in the discharged
water.
If the end of the drain hose touches the discharged water
(water drained from the washing machine), it (the discharged
water) may be sucked back into the appliance and damage
the appliance or garments.
This is a slight heating effect of the electronic components on
the PCB board installed on the back of the control panel.
Your appliance contains sensors that monitor progress during
the wash cycle (e.g. water level, temperature, unbalanced
loads, wash time/progress). Normally, if your appliance
completes the cycle successfully, it is unlikely that there will
be a problem.