Smeg ECF02 Manual Del Usuario página 13

• The LEDs start to flash in sequence.
• Press the key corresponding to water
hardness:
Soft
Medium
<10°dH 10°dH - 20°dH
<18°fH 18°fH - 36°fH
<180 mg/l 180-300 mg/l
CaCo3 CaCo3
• The key selected flashes to indicate the
selection has been stored and a single
sound is emitted if the acoustic signals are
activated.
To prolong machine operation and
preserve the aroma and flavour of
the coffee, use of the Smeg Water
Softener Filter is recommended
(optional, not supplied). For
installation and operation, follow
the instructions accompanying the
accessory. Once installed, set the
level of water hardness at "Soft",
following the indications in the
previous paragraph.
Setting the automatic shut-off time
In order to save energy, the coffee machine
has an automatic shut-off function and will turn
itself off when it has not been used for a certain
period of time.
To turn the appliance back on, press any button
on the control panel.
To set the automatic shut-off time:
• Access the programming menu (see section
"3.6 Access programming menu and
change settings").
Use
Press the key (22) to set the automatic shut-off
time.
• The key (22) flashes 3 times, after which
the current setting LEDs turn on:
Hard
>20°dH
>36°fH
360 mg/l
CaCo3
• The LEDs start to flash in sequence.
• Press the button corresponding to the time
you wish to set, choosing from 10 minutes
(20), 30 minutes (21) or 1 hour (22).
• The key selected flashes to indicate the
selection has been stored and a single
sound is emitted if the acoustic signals are
activated.
Restoring factory values
To restore factory settings:
• Hold keys (21) and (23) down simultaneously
for at least 10 seconds.
• All of the buttons will flash together once to
indicate that the original settings have been
reset.
Activation/deactivation of acoustic
signals
• The machine is set by default with the
acoustic signals deactivated.
• The acoustic signals can be disabled/
enabled by holding keys (20) and (23)
down for 5 seconds;
• The key (20) flashes three times indicating
that the setting has been stored.
LEDs Time setting
10 minutes
30 minutes
1 hour
EN - 13