Publicidad
Idiomas disponibles
Idiomas disponibles
must be physically able to perform the necessary operations on the
machine as well as being able to safely operate and maintain it. The
machine is to be run only by authorised operators who have read this
manual and who have been trained in its operation.
WARNING
Operators or users shall be responsible for any accidents
or hazards that may affect other persons or their property.
WARNING
Users may not operate the machine if they are taking any
substances (alcohol or medication) which might impair
their normal levels of perception or awareness or
compromise their reaction times.
2.6 IMPROPER USE
Any uses other than those described in this manual shall be
considered improper and therefore not in compliance with safety
regulations.
WARNING
Improper use of the machine may result in personal injury,
death, and/or damage to the machine or other equipment.
Below is a list of possible misuses that could result in personal injury
or damage to the machine or other equipment:
•
Unauthorized modification or replacement of machine parts;
•
Failure to comply with safety instructions;
Failure to comply with instructions concerning installation,
•
operation, maintenance, repair, or if these operations are
performed by unqualified personnel;
•
Use on improper and incompatible surfaces.
3. USE AND TECHNICAL DATA
3.1 USING THE MACHINE
The high-pressure washer is a professional machine for high-
pressure washing with cold water. It is intended for cleaning tools,
machines, vehicles, buildings and other surfaces that can be treated
with a high-pressure water jet; any other use not mentioned must be
considered improper.
3.2 CONDITIONS OF USE
The high-pressure washer has been specifically designed to perform
only the functions described in this section of the manual. The
machine must be operated under environmental conditions that
comply with those described in the section on admissible
environmental values.
3.3 NOISE
Lp dB(A) 88,6 – Lwa dB(A) 102,1 (margin of error 1.5)
Values obtained in compliance with UNI EN ISO 3744:2010
3.4 VIBRATIONS
The vibrations produced are so slight that they cannot be a source of
danger to the operator.
WARNING
No special precautions are required to protect the
operator from the effects of any vibrations produced. If
abnormal vibrations do occur, the operator is to stop the
machine immediately and report the phenomenon to the
maintenance supervisor.
L-LC232.00-BM
EN
3.5 PROTECTION GRADES OF THE MACHINE (IP)
Degree of protection against solid foreign bodies
(protected against dust)
Degree of protection against water (protected against
jets of water)
3.6 ADMISSIBLE ENVIRONMENTAL VALUES
Admissible environmental values
Admissible
temperatures
Changes
of
temperature
Range of relative humidity
Vibrations
The machine is not intended to operate in environments with risk of
fire or explosion.
WARNING
The machine must not be used where there is an explosive
atmosphere. Machines, and their components or
equipment designed to operate in explosive atmospheres,
must bear the ATEX mark as provided for in standard EN
60079-14 (CEI 31-33) "Electrical installations for
explosive atmospheres with the presence of gas".
4. TRANSPORT AND INSTALLATION
4.1 HOISTING AND HANDLING
WARNING – Comply with the instructions below.
The machine will be delivered by the manufacturer packed in a
cardboard box and on a wooden pallet. Before unpacking, it may be
transported and handled using a forklift truck with a load capacity
greater than 250 kg.
Straps
Carton
To unpack the machine, cut the straps that secure the carton to the
pallet and then remove it. Once unpacked, the machine can be lifted
operational
-10°C ÷ 40°C
(50° F ÷ 113° F)
ambient
Max. 1.1°C / Min
(Max 2°F / Min)
75% or less
≤ 0.5 G
5
4
Pallet
24 / 40
Publicidad
