BM2 BIEMMEDUE MAGNUM 4S Serie Manual De Instrucciones página 26

The machine must be stopped and switched off before performing
any cleaning operations. Comply with the warnings below when
cleaning the machine or any of its parts:
Never clean electrical equipment using water or other fluids.
•
To remove any dust deposits use only a clean brush or a dry cloth.
•
• Do not clean plastic surfaces with alcohol, detergents or
solvents.
Dispose of cleaning materials responsibly pursuant to current
•
applicable regulations.
Do not release used materials or cleaning residues into the
•
environment.
• Clean using water or compressed air and soft cloths.
WARNING
During cleaning it is mandatory to put on personal
protective equipment.
8.3 SAFETY STANDARDS FOR REPAIRS AND EXTRAORDINARY
MAINTENANCE
The manufacturer recommends that an authorized repair shop be
contacted for any operations that do not fall under normal
maintenance.
WARNING
These operations are to be carried out only by qualified
personnel, who have all the technical skills to perform
these operations safely and in full compliance with the
applicable laws in force.
It should be pointed out that the right to the warranty offered by the
manufacturer shall be void if:
• The instructions given in the "use and maintenance manual" are
not scrupulously complied with;
The scheduled maintenance services are not carried out;
•
Lubricants other than those indicated are used;
•
Repairs or maintenance are carried out by unqualified personnel;
•
Non-original spare parts are used;
•
• Unsuitable work equipment is used.
WARNING
It is the Customer's responsibility to verify that only
original spare parts, which are the only parts that will not
compromise machine safety, are used for repairs.
When ordering spare parts, ensure that the machine model, the serial
number, the part reference number from the spare parts booklet and
the quantity are specified to the manufacturer.
9. MACHINE STORAGE CONDITIONS
9.1 MACHINE DECOMMISSIONING
If the machine will not be used for significant periods of time, it will
be sufficient to protect the raw parts (those not protected by paint,
surface treatments or plastics) with rust preventive oils. If the
machine is to be removed from service for a significant period of time,
it should also be thoroughly cleaned. Completely empty the tank and
run the engine until it stops. Once these operations have been
completed, seal the machine inside an opaque multi-layer black nylon
bag where an appropriate desiccant (silica gel packets) has been
inserted beforehand. For instructions regarding the internal
combustion engine, follow the instructions described in the use and
maintenance manual of the engine installed.
L-LC232.00-BM
EN
10.1 MACHINE DISPOSAL
At the end of its working life, this machine is to be scrapped and
disposed of by handing it over to the local separate waste collection
system pursuant to and in scrupulous compliance with current
legislation. Before scrapping, check the machine's serial number
label. If the label bears this symbol
regulated by Legislative Decree no. 151 of 25/07/2005 and directive
2002/96/EC on Waste Electrical and Electronic Equipment (WAEE).
You should therefore become apprised of the local waste collection
system for electrical and electronic products and comply with its
requirements. Improperly disposing of this product as normal
municipal waste may result in serious harm to the environment and
human health, and may be subject to penalties from local authorities.
11. PERIODIC MAINTENANCE TABLE
PROCEDURE
Check operation of all
controls
Check the fittings gaskets
Check pump oil level
10. DISPOSAL
, this means that disposal is
X
X
X
X
26 / 40