Sharp RT-350H Manual De Manejo página 16

RECORDING
@When making important recording, be sure to make a test
recording before recording the important material.
RECORDING FROM AN AMPLIFIER
vw Operate the unit in numerical order.
67
] Switch on both the amplifier and the RT-350H. 8
2 Set the INPUT selector switch on the rear panel to either LINE or
(DIN)JMIC position depending on how the unit is connected to
amplifier— either through LINE IN socket or through DIN socket,
In the latter case, microphone must be disconnected.
2 INPUT
(DIN)
LINE MIC
9 II
To suppress tape hiss, set the DOLBY NR switch to the-ON
position and choose either B or C type noise reduction. If this
circuit is not needed, set the DOLBY NR switch to the OFF
position.
e Recordings made with the DOLBY NR circuit on must be played
with this circuit on for the best results.
Set the function selector on the amplifier forthe programme you © Push the RECORD button. "The RECORD indicator and the
wish to record, and increase thé volume level slightly.
4, Push the EJECT button to open the cassette compartment door.
Place the cassette tape on which you wish to record with side A
{1} facing towards you, into the compartment.
6 Push the DIRECTION button to light the indicator to the side
which you wish to record on (orp).
@When recording on both sides, light the indicator toP>.
PAUSE indicator wil! light and the unit will be in the recording
stand-by mode.
@ Pushing the RECORD button will turn off the SINGLE PRO-
GRAM and REPEAT indicators.
® If the cassette tabs have been broken off, pushing the RECORD
button will not set the unit in the recording stand-by mode.
When recording both sides, if one of the tabs on the cassette
has been broken off, this will not allow both sides to be
recorded.
Recording from side A to B can be done, however, recording 10 Adjust the recording level with the RECORD LEVEL controls so
fram side B to A is not possible.
7 To record from side A to side B, push the AUTO REVERSE button.
The AUTO REVERSE indicator will light.
TI
(E] 14
that the loudest sounds to be recorded turn the "O" indicator of
the record level meter off and on. If the level is set too high, the
recording will have distortion, and if set too low, the recarding
will have noise.
@ When recording from an FM tuner that provides an AJR-CHECK
calibrator, activate the calibrator and turn the RECORD LEVEL
controls down to the "O" position and then adjust the controls
sa that the peak Jevel meter shows constant illumination at "—3
dB".
Push the PLAY Button to start recording.
@ The volume and tone controls on an amplifier may be adjusted
with no effect on the recording level input signal.