Descargar Imprimir esta página

Westinghouse iGen4000c Manual Del Usuario página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
DATA CENTER
See Figure 11.
Push the mode button to cycle through the data display
modes.
Voltage: Displays current voltage output.
Frequency (Hz): Displays power output frequency in Hertz.
Lifetime Hours: Displays the lifetime run hours.
Fuel Level: Indicates how much gasoline remains in the
fuel tank.
Run Time/Maintenance: Displays current run time. Resets
to zero when shut down. Maintenance reminder displayed
when required.
Maintenance Codes:
  P25 – Change engine oil
  P50 – Clean air filter, Change engine oil
  P100 – Change engine oil, clean air filter, replace fuel filter
BREAK-IN PERIOD
For proper break-in, do not exceed 50% of the rated running
watts during the first five hours of operation.
Use supplied oil until first recommend oil change. Do not
use full synthetic oil during break in period. Full synthetic oil
may prevent proper breaking and seating of the piston rings.
Vary the load occasionally to allow stator windings to heat
and cool and help seat the piston rings.
BEFORE STARTING THE GENERATOR
Verify that:
l The generator is placed in a safe, appropriate location.
l The generator is on a dry, flat, and level surface.
l Oil and fuel levels are within safe operating range.
l All loads are disconnected from the control panel recep-
tacles.
l The ECO mode switch is in the OFF position.
DANGER
NOT move or tip the generator during operation.
REMOTE START
See Figure 12.
The remote start key fob included with the generator is
stored in the remote storage compartment. If your unit was
shipped without a key fob, contact Westinghouse customer
service.
The generator can be started remotely from up to 99 feet
(30 meter) using the remote start key fob.
NOTE: As the batteries in the remote start key fob drain,
operational distance will decrease.
Pairing the remote start:
If the remote start key fob is replaced or needs to be paired
to the generator, follow this procedure:
Fire and explosion hazard. DO
FIG. 11
A
C
E
A - Voltage
B - Power output
C - Lifetime hours
D - Fuel level
E - Run time/maintenance reminder
F - Mode button
FIG. 12
A
B
D
E
A - Activity light
B - Remote
C - Remote control storage compartment
D - Remote ON/OFF buttons
E - Electric start button
F
B
D
C
English | 17

Publicidad

loading