Legal Information; Trademarks - Ottobock TerraFlair Instrucciones De Uso

Sealing the hole
1) Locate the puncture.
INFORMATION: If the puncture is not visible, inflate the air chamber, close the valve
and immerse the insert in water. The puncture should be detectable by the air bubbles
escaping from the insert.
2) Follow the instructions for repair provided with the repair kit (see fig. 7).
3) Re-inflate the ROHO insert with air.
4) Immerse the ROHO insert in water to check that the puncture has been sealed.
Inserting the ROHO insert
1) Dry the ROHO insert thoroughly.
2) Place the ROHO insert on the table. The tube faces forward (see fig. 21, item 1).
3) Position the foam base over the ROHO insert. The wedge faces forward (see fig. 22, item 1).
4) Use the hook-and-loope closures to fix the foam base to the ROHO insert so that it is secured
against sliding.
5) Put the cover back on (see Page 18).
6) Set up the cushion for the user again (see Page 17).

8 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
8.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as class I accessories according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
8.3 Service Life
Expected service life: 2 years.
The design, manufacturing and requirements for the intended use of the product are based on the
expected service life. These also include the requirements for maintenance, ensuring effective­
ness and the safety of the product.
Using the product beyond the specified expected service life leads to increased residual risk and
should only happen subject to the due diligence and deliberations of qualified personnel.
If the service life is reached, the user or a responsible attendant should contact the qualified per­
sonnel who fitted the product or the manufacturer's service (see inside rear cover or back page
for address). Here the user can obtain information about known risks and the current options for
refurbishing the product.

8.4 Trademarks

All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
20