GB
IMPORTANT
For the instructions relative to the engine and
the battery, please read the relevant instruction
handbooks.
Equipment which is marked with an asterisk (*)
comes as standard in certain models or countries.
Certain models do not have throttle control. The
engine's speed is set for optimal function and min-
imal exhaust emissions.
SYMBOLS
The following symbols can be found on the
machine to remind you of the care and attention
that are required during use.
The symbols mean:
Important: Read the instruction handbook
before using the
Warning! Keep onlookers away. Beware of
objects being flung out.
Warning! Keep hands and feet clear of the
cutting deck when the machine is running.
Warning! Before starting any repair work,
remove the spark plug cable from the spark
plug.
Warning! Always tilt the lawnmower
backwards
underside. Petrol and oil can run out if the lawn-
mower is tilted in the other direction.
INTRODUCTION
G
Type I
ENGLISH
when
cleaning
the
J*
H*
K*
G
Type II
L*
Type III
G
Start/Stop loop
H
Throttle control (*)
J
Clutch loop (*)
K
Electric start (*)
L
Variator control (*)
INSTALLATION
LOOSE PARTS IN THE BOX
2 brackets for the grass collector
4 screws for the brackets
1 ignition key (*)
1 battery charger (*)
1 Allen key
1 socket wrench
+ Instruction books
HANDLE (Type I-II)
1. Fold up the lower part of the handle.
2. Secure the upper part of the handle with wash-
ers and locking wheels. There is a lug on the
right hand side for the starter handle (fig. 1).
3. Then tighten the locking wheels onto the lower
part of the handle. When these have been tight-
ened, the height of the handle can be adjusted
by tightening the screws A with the wrench pro-
vided. (fig. 2)
HANDLE (Type III)
1. Unscrew the locking wheels from the chassis
and secure the lower part of the handle onto
screws B (fig. 3).
33
H*
K*
G
J*
J*
H*
G
GB
J*