Publicidad
Idiomas disponibles
Idiomas disponibles
9. Take out the screws on the top left-hand side of the unit and replace them on the top right. Turn
the upper hinge round through 180°. Unscrew the hinge pin and reposition it in the other
opening in the hinge. Unscrew the hinge pin and reposition it in the other opening in the hinge.
Fit the hinge pin into the corresponding opening in the door and tighten the screws to the secure
the upper hinge to the housing.
Replace the top cover and secure it by tightening the holding screws. Finally, replace the screw
covers.
10. Now change the position of the door handle:
Take off the screw covers, remove the screws and then take off the handle.
Remove the blind covers on the other side of the door and reposition the handle in the new
location.
Replace the blind covers on the other side.
11. Put the unit back in its intended position and wait for about two hours before connecting it to
the mains.
Temperature control
The unit is activated by connecting it to the mains. It is only switched off
completely when the plug is removed from the wall socket.
The temperature in the refrigerator cabinet can be adjusted by setting the
temperature control. Turning the control clockwise will decrease the
temperature, while turning it anti-clockwise will increase it.
–
After switching on, the temperature control should be set to its highest setting.
–
After approx. 30 minutes, the temperature should be changed to a medium setting, which is
usually sufficient for home or office use.
20
Publicidad
