Publicidad
Idiomas disponibles
Idiomas disponibles
–
For frequent cleaning we recommend the use of warm water with some mild detergent. To
prevent any unpleasant odour within the refrigerator, it should be cleaned about once a month.
–
Any accessories should be cleaned separately with soapy water. Do not put them in a dishwasher.
–
Do not use abrasives or harsh cleaning solutions or any cleaning agents that contain alcohol.
–
After cleaning, thoroughly clean all surfaces with fresh water before wiping them completely dry.
When re-inserting the plug into the wall socket ensure that you have dry hands.
–
To save energy and to ensure optimum performance, the compressor (at the rear) should be
carefully cleaned at least twice a year, with a brush or a vacuum cleaner.
–
Take care not to remove or damage the rating plate inside the cabinet during cleaning.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are:
–
caused by the electric motor within the compressor assembly;
during compressor start-up the sound level will be slightly higher
for a limited period of time.
–
caused by the cooling agent flowing through the circuit.
The following table lists the possible malfunctions, their probable causes and solutions. In the event
of operational problems, check first whe ther a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department
Problem
The appliance is not working.
The normal operating sound
changes or becomes louder.
Water is collecting on the
bottom of the unit.
Transporting the unit
The unit must be transported only in its vertical position.
Do not tilt it to more than 45°. During transport, ensure that the unit is properly secured and
protected against shock, vibration and shifting.
To ensure proper functioning after transportation, wait for around two hours before connecting the
unit to mains power.
Possible cause and solution
–
There is a power failure
–
The main fuse has blown.
–
The temperature control is set to '0'.
–
The fuse in the wall socket (if applicable) has blown. This can
be checked by connecting another electrical device to the
socket and checking for function.
–
Check for proper positioning (uneven floor?).
–
Are any adjacent objects affected by the running of the
cooling unit (i.e. caused to vibrate?)
–
Are there any objects on top of the unit which might be
vibrating?
The melt-water drain system is blocked. Remove the blockage and
clean the system.
22
Publicidad
