Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
be installed.
Warnings
- Surfaces in direct contact with the hob must be heat resistant (min. 95 °C).
- The appliance can be installed on a worktop with a thickness between 30 and 40
mm and close to walls that are higher than the worktop, maintaining a minimum
distance of 100 mm.
- Make all relevant cuts in the surface/countertop and then carefully remove any
shavings or sawdust before fitting the hob.
- To ensure correct ventilation of the hob, respect the dimensions indicated in figures
2 and 3.
- Make sure that the surface is level and square and that no parts interfere with the
space required for installation.
- Cut as shown in figures 2 and 3.
Installation
Warning: risk of cuts!
- Be careful with the edges, as you could cut yourself.
- The edges are protected with polystyrene, be careful.
- During transport they may cause minor injuries or cuts.
- Take the hob and the instruction manual out of the box.
- Before assembling and installation, carefully read this instruction manual.
Step 1:
Place a towel or cloth on the worktop surface and place the hob face down on it. Fig. 4
Step 2:
- Place the sealing tape supplied with the hob to seal it on the worktop surface.
- Do not use silicone. Apply the tape to the edge of the bottom of the hob, leaving
about 3 mm from the edge of the glass.
- Apply the tape all around the perimeter.
- Cut off the excess and join the two ends of the tape to match. Fig. 5
Step 3:
Secure the brackets (4 pieces) at the front and rear with screws. Place the hob in a well
centred position on the pre-cut board or worktop. Make sure that the front edge of
the hob is parallel to the side edge of the worktop. Fig. 6
Please note:
- Ventilation requirements shown in figure 7 must be respected.
- There are ventilation holes around the exterior of the hob. You must ensure these
31
EVVO PLACA VITROCERÁMICA V60
Publicidad
