Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
official EVVO Technical Support Service to avoid any potential risk.
- The power cable must be replaced according to the following instructions:
o Switch off the appliance.
o Open the terminal block located at the bottom of the hob.
o Unscrew the terminal screws securing the cable.
o The "green, yellow" earth cable must be connected to the marked terminal. It should
be about 10 mm longer than the power and neutral cables.
o The "blue" neutral cable must be connected to the terminal marked with the letter
(N) - the power cable must be connected to the terminal marked with the letter (L).
o The "blue" neutral cable must be connected to the terminal marked with the letter
(N) - the L1 power cable must be connected to the terminal marked with the letter
(L1). The L2 cable must be connected to the terminal marked with the letter (L2) (380-
420V 2N~).
4. OPERATION
1.Switch on
When the power is turned on, the hob will beep once to indicate that the power is on.
Then, all indicators on the display will light up for 2 seconds. Next, the appliance will
go into shutdown mode.
Please note
The corresponding decimal point indicator will light up on the display.
Shutdown mode: the entire display will turn off except for the residual heat indicator
light. Except if you press and hold the power icon, the rest of the icons will not be
activated.
2. Standby mode
- When the hob is switched off, press and hold the power icon for 3 seconds. The hob
will beep and enter standby mode.
- The indicators in the cooking zone will show the "-" symbol. The high temperature
symbol will be shown on the cooking zone display if there is residual heat. The time
display will show "--" as well.
- If no cooking zone is activated in standby mode, the appliance will automatically
switch off after 10 seconds and beep.
3. Switch-off
In standby or heating mode, press and hold the power icon for 3 seconds, a short beep
will sound and the device will switch to off mode. If the surface of the relevant cooking
zone currently has residual heat, the power level indicator display will show "H" and
33
EVVO PLACA VITROCERÁMICA V60
Publicidad
