Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
gaps are not blocked by the worktop when placing the hob.
- Do not use a silicone sealant to seal the device. This will make it difficult to remove
the hob in the future, especially if maintenance work is required.
- When fitting the hob, turn it carefully and place it gently into the recess in the
worktop.
Installation guidelines. Fig. 8
- The nominal voltage of the hob heating elements is 230 V. The ceramic hob can be
adapted for single-phase operation by means of a suitable bridging in the junction
box according to the wiring diagram shown in the figure. The wiring diagram can
also be found on the junction-box cover. Remember that the connection cable must
match the type of connection and the power rating of the ceramic hob.
- The connection cable must be fixed in a strain relief clamp.
Warning!
- Remember to connect the safety circuit to the terminal in the junction box.
- Before connecting the ceramic hob to the mains, it is important to read the
information on the rating plate and the wiring diagram.
- The cable connections must be made in accordance with the wiring diagram on the
bottom of the hob.
- You must use a good quality screwdriver to carefully and completely tighten ALL
terminal screws.
- If both zones do not work when you switch on the hob for the first time, you should
double- check that all terminal screws are tightened securely. This must be done
before contacting the official EVVO Technical Support Service.
Important
- DO NOT connect the appliance to the mains using a 13 A plug and socket.
- It must be connected to a 30 A double-pole fused socket outlet, with a contact
separation of 3 mm and located in an easily accessible place next to the appliance.
It must not be placed above the appliance or more than 1.25 m from the appliance.
- The cable can be coiled, if necessary, but make sure that the cable is not kinked or
pinched when installing the hob. Do not allow the cable to come into contact with
hot parts of the appliance.
Replacing the power cable. Fig. 9
- If the power cable is damaged, it must be replaced by the manufacturer or the
32
EVVO PLACA VITROCERÁMICA V60
Publicidad
