Publicidad
Idiomas disponibles
Idiomas disponibles
A
B
D
MAX
Maintenance
To extend the life of your appliance, we recommend that you rinse
the steam generator and clean your iron every month or after every
10 hours of ironing.
WARNING: the appliance should be UNPLUGGED, OFF and
COLD before cleaning. Switch off and unplug the appliance.
Allow your appliance to cool down for at least 2 hours.
Always make sure your appliance is cold before cleaning !
NOTICE! Only rinse the appliance with water. NEVER use descaling
products or other chemical products.
Cleaning the iron (2)
If the iron's soleplate is dirty, use the cleaning mat in accordance with
the instructions. This can be obtained at www.laurastar.com or from your
approved Laurastar retailer.
Stubborn stains can be cleaned using an abrasive dishwashing sponge. After
completing this operation, remove the aluminium oxide present under the
soleplate by cleaning it with a damp cloth.
C
Clean the steam holes in the iron's soleplate as soon as they become blocked
up or calcified.
C
Anti-scale filter change (13)
The anti-scale filter has to be changed when the granules are
completely brown.
• Remove the water reservoir (11) from its place. Take off the water reser-
E
voir lids. Remove the anti-scale filter (13).
• Dispose of the filter (13) in the regular houshold garbage and rinse the
compartment. Install a new anti-scale filter in the water reservoir.
• Fill the reservoir with tap water. The filtered water must reach the MAX
level. Then put the reservoir back in its place on top of the steam gene-
rator (15).
F
Note: you can wash the plastic elements of the water reservoir (11)
F
- 13 -
A
B
D
E
Publicidad
