Publicidad
Idiomas disponibles
Idiomas disponibles
A
B
C
D
NOTE: Before ironing, or after an extended break, press the
iron's steam button (9) or times, while pointing it away from the
clothes. This will release any condensation from the iron and
prevent water marks on the clothes.
CAUTION : Do not point the iron at people or pets while using
vertical steam.
Ironing
Two ironing modes
For the best possible steam ironing result, we offer two modes of ironing :
• Blower mode :
Pressing the vacuum/blower button (10) on the iron
A
activates the fan (24) in blower mode. this blows air into the fabric from
below, helping to reduce unwanted creases.
• Vacuum mode :
Pressing the vacuum/blower button (10) again,
B
activates the fan (24) in vacuum mode. This draws in air, holding the
garment in place on the board to facilitate perfect pleats.
Press the vacuum/blower button (10) to switch from blower to vacuum mode
and vice versa. You can adjust the intensity (4 speeds) pressing the fan speed
button (19) on the user interface of the steam generator.
LAURASTAR SENSTEAM (17) (certain models only)
Laurastar SenSteam (17) allows you to obtain an automatic steam diffusion
without pressing the steam button (9). The steam is automatically activated
when the iron moves forward and stops when the iron rests or moves back
To switch back to regular mode, press the Laurastar SenSteam button (17)
again.
PULSE (18) (certain models only)
Press the pulsed steam button (18) to activate the pulse function. Then press
the steam button (9) to automatically generate small and regular steam jets
To switch back to regular mode, press the pulsed steam button again (18).
Steam principle
Perfect ironing requires diffusion of steam across the fabric, in order to relax
the fibres, and drying to fix them in place. Creases can only be completely
removed if these conditions are present.
Advice: For best results, first iron the item with steam and then iron it again
without steam, thereby enabling the iron to dry the fabric.
- 10 -
EN
.
C
.
D
Publicidad
