Publicidad
Idiomas disponibles
Idiomas disponibles
A
B
MAX
ON/OFF
SenSteam
Pulse
Fan speed
Water
C
3-6 min.
10 min.
Start up
CAUTION: Always fill the water reservoir (11) completely
before turning on your Laurastar. Operating the appliance
without water could damage the appliance.
PLEASE NOTE: Operating the appliance without water will void any
limited warranties provided with your appliance.
Installation of the anti-scale cartridge and filling
• Check that the power plug is disconnected from the mains socket.
• Set the ironing board to its highest position.
• Take the water reservoir (11) out. Take off the water reservoir lids.
Install the anti-scale filter (13).
• Fill the reservoir with tap water. The filtered water has to reach the
MAX level.
B
• Close the water reservoir with the lids and put the reservoir back on the
steam generator (15).
• If the water does not flow, soak the anti-scale filter in cold water for
3 minutes.
User interface
• ON/OFF = the green indicator light flashes until the appliance is ready to
be used.
•
= Option Laurastar SenSteam. If your appliance is equipped with the
Laurastar SenSteam option (17), the white indicator light signals that the
function is on.
•
= Option Pulsed Steam. If your appliance is equipped with the Pulsed
Steam option (18), the white indicator light signals that the function is ON.
Fan speed button (19) = choice of four speeds. The white indicator light
signals the intensity chosen.
• Empty water light (20) = the red drop shaped indicator light signals that
there is no more water in the reservoir (11).
Switching on your appliance
• Insert the power plug (23) in the socket. If your model is equipped with the
automatic rewinder, first pull the electric cable untill the end-of-cable mark
is visible at the rewinder opening.
• Press the main ON/OFF button (16), the green indicator light will flash for
3-6 minutes.
C
• When the green indicator light stops flashing and stays on, the appliance is
ready. You can start ironing.
• NOTE: For your comfort and safety, your Laurastar system will
switch off after 10 minutes of non-use.
- 9 -
A
Publicidad
