elobau eloProtect M 153MSK 0 1 Serie Manual De Instrucciones página 27

6.5. Disposal
The symbol means that a product must be collected separately from other waste when
it reaches the end of its service life in accordance with directive 2012/19/EU. For more
information, please contact elobau or your dealer on site.
Dispose of packaging and used parts according to the regulations of the country in
which the device is installed. Do not dispose of the safety sensor with domestic waste;
e.g. dispose of at the collection centre of a waste management utility.
7. Appendix
7.1. Actuator operating directions and dimensions
See page 67 and 68.
For further information on actuators, please contact elobau GmbH & Co. KG for the re-
spective datasheets.
7.2. Contact variants
All safety sensor contacts are presented in a deactivated state (open protective door).
For safety sensors with connecting cable and plug the pin assignment is specified (see
Figure 1: Connector, page 24).
Wire colours are stated for safety sensors with connection cable. The first (1/2 or BN /
WH) and the second (3/4 or BU / BK) contacts are safety contacts. The third contact
(GY / PK or 5/6) is the control contact.
Pay attention to the polarity for variants with LEDs!

See page 69.
7.3. EU Declaration of Conformity
See page 70.
18.01.2024 V2.0
Appendix
27/72