Publicidad
When operating, the entire capacity of the cooperating indoor unit should be not
larger than 150% of outdoor unit. Otherwise, it will cause the shortage of cooling
(heating) capacity.
The total capacity of the indoor units which runs at the same time can not exceed
150% of that of the outdoor units, otherwise, the cooling (heating) effect of each
indoor unit would be poor.
Switch the main power on 8 hours before starting the unit, helpful for a successful
startup.
A Breaker (or fuse) need to be installed in every indoor unit, and the capacity
should in according with indoor unit's electrical parameter; all the indoor units are
required to be centralized controlled by a total Switch, this Switch can cut off the
electric power supply in case of emergency. The Breaker (or fuse) on each indoor
units have the function of short circuit prevention and abnormal overload avoiding,
it should be connected in normal situation. The total switch controlling the power
supply of all the indoor units. Before clearing and maintenance job being carried
out to the indoor units, it is very important to turn off the total power supply switch.
In order to turn on the units successfully, the main power switch should be opened
8 hours before the operation.
After receiving the turn off signal, every indoor unit will continue to work for
20-70sec to make use of the rest cool air or the rest heat air in the heat exchanger,
while preparing for the next operation. And this is normal.
When the selected operating mode of the indoor unit are clash with the operating
mode of the outdoor unit, the malfunction light will blink after 5s on the indoor unit
or remote controller showing that the operation clash, then the indoor unit will stop.
At this time, change the operation mode of the indoor unit to the one that would
not clash with the outdoor operating mode to make the operation n ormal. The
cooling mode is not clash with the dry mode, while the fan mode is not clash with
any mode.
The appliance shall not be installed in the laundry
An all-pole disconnection switch having a contact separation of at least 3mm in all
poles should be connected in fixed wiring
Information regarding transport/storage temperature (-25-55° C) is missing
User Notice
Publicidad
