Publicidad
careful not to let the swing motor lead wire get caught in the sealing material.)
③. Screw the 4 hexagon head screws under the latches in about 15mm. (The
panel would rise)
④. Adjust the panel by turning it toward the direction pointed by the arrow as
shown in Fig. 2.13, so that the adjust board connect the ceiling well.
⑤. Tighten the screws until the thickness of the sealing material between panel
and indoor unit reduced to 5-8mm.
Notes:
① . Improper screwing of the screws may cause the troubles shown in Fig. 2.14.
Free Match For European Union
Fig. 2.13
11
Publicidad
