Publicidad
Free Match For European Union
Impact tightly by impact fastener after connection and then fit on the electric
box (1) and (2).
Connect the wiring (communication) through the piping hole of the chassis and
the bottom of the appliance upward, then connect the brown wire to the Terminal board
"3", black wire (the communication wire) to the Terminal board"2", blue wire to the
Terminal board"N(1)".and connect the earthing wire to the screw terminal on the electric
box.
2.9 Install the panel
(1) Set the panel to the indoor unit body by matching the position of the swing flap
motor of the panel to the piping position of the panel to the piping position of
the indoor unit as shown by Fig. 2.13.
(2) Install the panel
①. Install the panel on the indoor unit temporarily. When install, hang the latch on
the hook that is located on the opposite side of the swing flap on the panel of
the indoor unit. (2 positions)
②. Hang the remaining 2 latches to the hooks on the sides of the indoor unit. (Be
Fig. 2.12
10
Publicidad
