cecotec BOLERO COOLMARKET COMBI 262 WHITE E Manual De Instrucciones página 27

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Thermostat knob
2. Refrigerator glass shelves
3. Crisper-drawer cover
Crisper drawer
4.
5. Freezer-compartment drawers
6. Adjustable feet
7. Bottle holder
Note:
- The graphics in this manual are schematic representations and may not exactly match the
appliance.
- To make the most out of the refrigerator in terms of energy, place all the shelves and
drawers in their original position, that is, as shown in Figure 1.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content:
- Bolero CoolMarket Combi 262 White E refrigerator.
- Instruction manual.
3. PLACE OF INSTALLATION
1. Conditions for proper ventilation:
The location you choose for the installation of the refrigerator must be properly ventilated and
away from heat sources. Do not place the refrigerator near heat sources, like a cooker hob or
B O LE R O COOLM ARKET COM BI 2 62 W HIT E E
52
pot, and avoid direct sunlight to ensure the cooling effect and save on energy consumption. Do
not place the refrigerator in a damp place to avoid rust or loss of power. The result of dividing
the amount of refrigerant load by the total space of the room in which the refrigerator is
installed must not be less than 8 g/m³.
Note:
The amount of refrigerant used by the refrigerator is specified on the appliance marking.
2. Heat dissipation space
- During operation, the refrigerator releases heat into the environment. Therefore, you
should leave at least 30 mm of free space at the top chamber, more than 100 mm on both
sides, and more than 50 mm at the rear of the refrigerator.
- Dimensions in mm (Fig. 2):
W Depth Height
540 550 1760
Note:
Figure 2 only illustrates the space required for the appliance.
3. Installation surface
- Place the refrigerator on a solid, flat surface to keep it stable, otherwise vibrations and
noises will occur. When the refrigerator is placed on a carpet, straw mat, or polyvinyl
chloride, solid support plates should be placed under the refrigerator to avoid colour
change due to heat dissipation.
- It is necessary to maintain unobstructed ventilation around the appliance or in the
structure where it is installed.
4. Levelling
Make sure you level your refrigerator with the front levelling feet. If it is not levelled, the door
sealing performance of the refrigerator will be affected, or it can even cause a malfunction.
Preparing for use
5. Waiting time
Once the refrigerator is correctly installed and clean, do not turn it on immediately, wait at
least 4 hours before connecting it to the power supply to ensure normal operation.
6. Cleaning
Check the placement of the interior accessory parts and clean the inside of the refrigerator
with a soft cloth.
B OLERO COO LMARKET COMBI 262 W HITE E
ENGLISH
A B C(°) E F
910 1055 130±5 50 100
53