Vortice VORT HRI 200 PHANTOM BP IoT Manual De Instrucciones página 39

2 Product description
"Vort HRI Phantom BP IoT" (hereinafter "the appliance") is a centralised heat recovery ventilation system that can be
installed horizontally in a false ceiling. The appliance is controlled by an advanced electronic management system and is
equipped with fan motors with low-consumption EC Brushless motors. Inside the appliance is a heat exchanger (enthalpy
type in H models), which guarantees high levels of heat exchange efficiency.
The appliance can be controlled:
• Remotely from the wall-mounted remote control panel (with reduced functions).
• Via the "VORTICE MVHR" app (with Bluetooth connection).
• Via the "Vorticenet" cloud (with Wi-Fi connection), after registering the system at "www.vorticenet.it" or using the
corresponding "VorticeNET" app.
Both apps are available for iOS and Android systems.
Please refer to paragraph "Use" on page 53 for a detailed description of the various features the ventilation system offers.
3 Compliance
- This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance ina safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
- These appliances are designed for use in residential and commercial properties.
- The appliance must be installed by a professionally qualified electrician only.
- Ensure that the electrical system to which the appliance is connected complies with applicable
standards.
- An omnipolar switch with a contact opening distance of 3 mm or higher should be provided
for installation, enabling complete disconnection under overvoltage category III conditions.
- Products equipped with single-phase wiring (M) engines ALWAYS require connection to 220-
240V (or only 230V where required) single-phase lines. Any kind of modification shall be
considered as product tampering and shall nullify the relative Warranty.
- Precautions must be taken to prevent gas coming from the gas flue pipe or from other fuel
combustion units from entering into the room.
4 Safety/Warnings
o
OBLIGATION
- After removing the appliance from its packaging, ensure that it is complete
and undamaged. If in doubt contact an authorised Vortice service centre. Do
not leave packaging within the reach of children or differently able persons.
- Store the appliance out of the reach of children and disabled persons if you
decide to disconnect it from the power supply and use it no more.
- Connect the appliance to the electrical power supply/socket only if the rated
power of the supply is compatible with the maximum rated power of the
appliance. If not, contact a professional electrician without delay.
- The appliance must expel air directly to the outside through a single dedicated
duct.
- Specifications for the power supply must correspond to the electrical data on
ID plate A (fig.1).
ENGLISH
1
A A
39