Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Locating the coldest position in the refrigerating compartment
The adjacent symbol indicates a temperature of at least 4 °C and colder in the refrigerator
(above the glass shelf over the vegetable drawer) approx. 8 cm from the rear wall.
•
If "OK" does not appear, the average
temperature in this area is set too hot.
•
Set the temperature regulator to a colder setting.
Only change the temperature regulator gradually
and wait for approximately 12 hours before
checking again.
•
If the sticker indicates "OK", it means that the
temperature regulator is set correctly and the
temperature in the appliance is correct.
The temperature in the cold store is 4°C or colder.
1. To avoid that the temperature in the area where
the "OK" symbol is displayed is too cold, warm
up the temperature control knob step by step by
one / half step (wait for about 12 hours before
checking again).
2. If "OK" is still visible, increase the temperature
by one or half a step (wait for about 12 hours
before checking again).
3. Repeat step 1 as long as "OK" is visible until the
centre point for the target temperature of 4 °C is
reached.
4. If the "OK" symbol is not visible, in reverse order
take one or half steps to make the temperature
controller colder (wait approx. 12 hours before
checking again).
➢ To keep the temperature within this range, do not adjust the position of
the temperature regulator.
➢ In refrigerating appliances with integrated fan function or NoForst
models, the sticker is not attached because the temperature inside these
appliances is uniform.
➢ The "OK" sticker is intended for use in this appliance only.
➢ If the display remains white, the temperature is too high. Increase the
temperature regulator by one position and wait about 12 hours.
➢
After loading the appliance and opening the appliance door, the display
may change for a few seconds.
Page | 44
Publicidad
