Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
13. Re-attach the pin previously removed in Step
9, page 8 into the downrod, then align the
hanger ball so the pin is captured in the
groove at the top. Pull the hanger ball tight
against the pin, then tighten the
preassembled set screw in hanger ball.
CAUTION
A loose set screw could result in a wobbly fan.
14. Measure approximately 6 to 9 in. of lead wire
from the top of the downrod assembly (C),
then cut off the excess. Strip insulation off 1/2
in. from the end of each lead wire.
13
C
14
10
Set screw
Lowes.com/harborbreeze
C
Publicidad
