Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING INSTRUCTIONS
WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring
this fan.
Note: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice.
Note: The remote in remote pack (I) has 16 different code combinations. To prevent possible
interference from or to other remote units, simply change the combination code in the transmitter and
receiver.
1. To set the transmitter code, remove battery
cover on the remote from remote pack (I) by
pressing firmly below the arrow and sliding
cover off. With a small screwdriver or ball point
pen (neither included), slide switches firmly up
or down. Once desired setting is made,
replace battery cover on remote.
Note: Factory setting is all up. Do not use this
position.
2. To set the code on receiver unit from the power
kit (J), slide switches to the same positions as
set on the remote.
1
2
12
ON DIP
Receiver unit
Lowes.com/harborbreeze
Remote
Publicidad
