Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Re-assemble the upper housing cover and
motor coupler washer to the motor. Secure
with six screws previously removed in Step 3,
page 6.
8. Remove the preassembled hairpin clip and
clevis pin from the bottom of downrod
assembly (C). Retain for later use.
Note: Make sure to keep loose hardware
separate to avoid confusion during installation.
9. Remove the hanger ball portion from the
downrod assembly (C) by loosening the
preassembled set screw in the hanger ball
until the ball falls freely down the downrod.
Remove the preassembled pin from the
downrod, then remove the hanger ball. Retain
the pin and hanger ball for later use.
7
A
8
9
Set screw
8
C
Lowes.com/harborbreeze
Publicidad
