Publicidad
Idiomas disponibles
Idiomas disponibles
BLADE BALANCING INSTRUCTIONS
If the fan wobbles when in use, turn off the fan and follow the steps below:
WARNING
The balancing clip must always be rmly pushed
onto the blade until it touches the edge of the
blade. Failure to do so could allow clip to
and cause personal injury.
1. Interchanging positions of adjacent blades (H)
can redistribute the weight and result in
smoother operation. If wobble decreases,
leave blades (H) as they are. If wobble
increases, switch back to original position and
attach the balancing clip from balance kit (DD)
to the mid-point on the top edge of one
blade (H).
2.
observe wobble. Repeat steps 1 and 2 for
each blade (H) and note which blade (H) has
the least wobble. On that blade (H), attach the
balancing clip to the top edge of the blade (H)
near the motor assembly (A). Restart the fan
and observe wobble. Stop the fan and move
the balancing clip in small steps toward the
end of the blade (H). At each incremental step,
turn on the fan and observe the wobble.
Determine the location of the balancing clip
that results in the least amount of wobble.
3. Peel the backing paper from one of the
weighted squares in the balance kit (DD).
the blade (H), centered at the balancing clip
location and between the edges of the blade
(H). Remove the balancing clip, start the fan
and observe. If the wobble still persists, repeat
steps 1 through 3 with the remaining balancing
clip and weighted square until the wobble
disappears.
1
off
2
3
19
Balancing Clip
Balancing Clip
H
A
Weighted Square
H
Balancing Clip
Lowes.com/harborbreeze
H
Publicidad
