BWT Ecoclear Manual De Instalación Y Mantenimiento página 3

BWT ECOCLEAR CARTRIDGE FILTER
The BWT Ecoclear Cartridge Filters do not require a media such as sand or D.E powder to operate, instead the
filter contains a cartridge element which is easily removed to clean or replace.
The BWT Ecoclear Cartridge Filters are ideal for use in swimming pool and spas. The BWT Ecoclear Cartridge
Filters is also ideal for use when backwashing is impractical.
This equipment must be installed and serviced by a qualified technician. Improper installation can create electrical
hazards which could result in property damage, serious injury or death. Improper installation will void the
warranty.
This manual contains important information about the installation, operation and safe use of this product. Once
the product has been installed this manual must be given to the owner/operator of this equipment.
1 INSTALLATION
Remove the cartridge filter from the carton and install the pressure gauge into the threaded port on the filter lid
provided. Using Teflon, wrap once around the brass pressure gauge thread in a clockwise direction and screw
into the threaded lid port.
Hand tighten the pressure gauge into the lid only for sealing.
Place the BWT Ecoclear Cartridge Filter into the required position. Ensure that it is on a flat level surface and is
aligned with the pump.
BWT Ecoclear Cartridge Filter has marked inlet and outlet ports.
Ensure that the pipe extending from the pump outlet is connected to the BWT Ecoclear Cartridge Filter marked
inlet.
Screw the supplied half barrel unions and tails onto the inlet and outlet before gluing the UPVC piping onto the
filter.
Use only the recommended glue for the connection pipes and fittings.
Cut and fit the pipe and fittings onto and the pump the BWT Ecoclear Cartridge Filter. REFER to Pump Installation
Manual for correct pump plumbing procedures.
It is best practice to fit all the cut pipe and fittings onto the filtration system before gluing; this will ensure that the
system has been aligned correctly.
Glue the pipe and fittings onto the pump, filter and pool return lines and allow the glue to set for 24 hours before
commissioning the system.
Version 1.0 / 2024-01
EN
3 / 16