Throttle Control; Special Accessories - Stihl FW 20 Instrucciones De Servicio

Release with combination wrench
If the cutting depth adjustment cannot be
released via the lever on the guide tube,
it can still be released with the
combination wrench.
The combination wrench can only
be used to release the cutting depth
adjustment when the engine is
switched off – do not touch the hot
muffler!
:
To release the cutting depth
adjustment, insert the combination
wrench (2) in the hole (3) and press
down in the direction of the arrow.
FW 20

Throttle control

To start the cut-off machine, refer to
"Starting / stopping the engine" in the
user manual for the cut-off machine.
The throttle is not actuated via the
handle on the cut-off machine, but via
the throttle control on the guide tube.
For this purpose:
:
Press down and hold the locking
button (1).
:
Pull the throttle control (2) until it
contacts the guide tube –
full throttle position
The speed of the cut-off machine
depends on the distance between
throttle control and guide tube.
When the throttle control is released
completely (no-load setting), the
locking button must be pressed
again before the throttle control can
be actuated.

Special accessories

Cutting direction indicator set
Water tank set
Pressurized water tank set
English
15