Brudden BS-500 Manual De Instrucciones página 57

Choke Position
Closed (Lever Up)
To start when the engine is cold, observe the following steps:
06 - Operate the ignition switch to the "On" position (I).
07 - Close the choke – lever raised (only when the engine is cold).
08 - Press the injector until the fuel goes down to the tank through the return hose.
09 - Operate half of the throttle.
10 - Hold the equipment with your left hand.
11 - With your right hand, slowly pull the starter cable until it engages.
12 - Pull the starter cable firmly and quickly until the first sign of starting.
13 - Open the choke (lower the lever).
14 - Trigger the starter.
Attention! After starting, allow the engine to warm up at idle speed for about 2 to 3 minutes.
Starting with the engine hot
Attention! Do not start the equipment's motor if the pump has problems.
Attention! Do not start the engine if the equipment is incomplete.
Open (Lever Down)
57