Brudden BS-500 Manual De Instrucciones página 63

PROBLEM
Engine out of power
Engine Failing
CAUSE
Dilated carburetor diaphragms
Blocked exhaust window
Work overload
Ground wire with poor contact
and/or broken
Damaged switch
Motor heated by work overload
Engine warmed up due to lack of
cooling
Engine over-temperature due to
incorrect fuel mixture
Carburetor out of tune
Low fuel in the tank
Tank vent clogged
Coil failing
Poor contact on the on-off switch
Bad spark plug terminal
connected
Excess carbonization in the spark
plug electrode
SOLUTION
Contact an Authorized Service Center
Contact an Authorized Service Center
Check the points of correct use of the equipment (check in the
manual)
Replacing the Grounding Wire
Replacing the switch
Check for correct use of the equipment (refer to this manual or
contact an Authorized Service Centre)
Cleaning the rotor and cylinder cooling fins
Drain; Replace with fuel in the proper proportion (see item 7.1 in
this manual)
Contact an Authorized Service Center
Refilling the Fuel Tank
Cleaning or replacing the vent
Contact an Authorized Service Center
Contact an Authorized Service Center
Connect the terminal properly
Clean the spark plug and adjust the electrode to 0.6 mm (see
item 8.6 in this manual)
63