Keysight U1731C Guia Del Usuario página 53

Measuring dissipation factor/quality factor/phase angle (D/Q/θ)
The dissipation factor (D), quality factor (Q), and phase angle (θ) values can be
displayed interchangeably by pressing the
the inductance, capacitance, or impedance measurement mode.
This setting is not applicable for DCR measurement.
Changing the test frequency
The test frequency is set to 1 kHz by default. Press the
test frequency.
Table 2-5 Available test frequencies
Model 100 Hz
U1731C
✔
U1732C ✔
U1733C
✔
Selecting parallel/series circuit mode (P/S)
The LCR meter can display parallel (
all ranges.
Press the
Series mode is set as the default setting. You can, however, change this power-on
behavior in the Setup menu. See
page 70 for more information on how to change the default measurement mode
(parallel or series) for subsequent power cycles.
Keysight U1731C/U1732C/U1733C User's Guide
120 Hz
✔
✔
✔
key for more than 1 second to toggle the parallel and series mode.
ZLCR
P S
Features and Functions
key when the LCR meter is set to
DQO
Limit
1 kHz 10 kHz
-
✔
✔ ✔
✔ ✔
) or series (
"Changing the initial power-on behavior"
key to select a desired
Freq.
100 kHz
-
-
✔
) mode data for
on
2
53