Keysight U1731C Guia Del Usuario página 62

2 Features and Functions
The
Null
Cal
– The relative mode cannot be activated if the display value is
NOTE
– Relative mode is only available in manual ranging; therefore, activation while
– The relative mode cannot be activated if the LCR meter is set at auto-ranging
Performing the open/short CAL
The CAL function offsets (corrects) the LCR meter's internal parameters as well as
external connector residues for further measuring. Performing this action will help
you to correct the influence for temporary uses.
There are three types of open/short CAL available:
– OS-Factory: Open/Short CAL is performed during factory calibration mode
– OS-User: Open/Short CAL is performed at every power-on option interval. It
– Open/Short CAL for single range and frequency by pressing and holding the
The corrections for the
meter. They are both calibrated at the terminal ends.
You can set the LCR meter to start up using the
short CAL from the Setup menu (see
62
annunciator is shown on the display while the relative mode is active. Press
again to exit the relative mode.
in autoranging will automatically set the LCR meter to manual ranging.
with data hold activated.
(security code protected). It covers all frequencies and all ranges.
covers all frequencies and all ranges. (see
key for more than 1 second.
Null
Cal
page 26
and are pre-stored in the LCR
page 76).
Keysight U1731C/U1732C/U1733C User's Guide
.
for the OS-User setup).
or open/