Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1: Turn off the engine.
Water Inlet
STEP 4: Disconnect the garden
hose from the water inlet on the
machine.
CAUTION: Always store your pressure washer
in a location where the temperature will not fall
below 32°F (0°C). The pump in this machine
is susceptible to permanent damage if frozen.
FREEZE DAMAGE IS NOT COVERED BY
WARRANTY.
1. Stop the pressure washer, squeeze spray gun
trigger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds,
until remaining water exits. Turn engine off
immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become
kinked.
6. Store the machine and accessories in a room
which does not reach freezing temperatures.
CAUTION: Failure to follow the above directions
will result in damage to your pressure washer.
When the pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through
the spark plug hole, pull the starter grip several
times and replace the plug. Then pull the starter
grip slowly until you feel increased pressure
SHUTTING DOWN AND CLEAN-UP
On-Off
Switch
STEP 2: Turn off water supply.
Pump
STEP 5: Engage the spray gun
safety lock.
STORAGE
KARCHER Surface Cleaner 9.802-898.0
STEP 3: Press trigger to release
water pressure.
Safety
Latch
STEP 6: Pull trigger bar to drain
water from surface cleaner swivel
and spray arm.
which indicates the piston is on its compression
stroke and leave it in that position. This closes
both the intake and exhaust valves to prevent
rusting of cylinder.
4. Cover pressure washer and store in a clean,
dry place that is well ventilated away from open
flame or sparks. NOTE: The use of a fuel
additive, such as STA-BIL
minimize the formulation of fuel deposits during
shortage. Such additives may be added to the
gasoline in the fuel tank of the engine, or to
gasoline in a storage container.
After Extended Storage
CAUTION: Prior to restarting, thaw out
any possible ice from pressure washer
hoses, spray gun or wand.
Engine Maintenance
During the winter months, rare atmospheric
conditions may develop which will cause an icing
condition in the carburetor. If this develops, the
engine may run rough, lose power and may stall.
This temporary condition can be overcome by
deflecting some of the hot air from the engine over
the carburetor area. NOTE: Refer to the engine
manufacturer's manual for service and maintenance
of the engine.
Trigger
bar
, or an equivalent, will
®
11
Publicidad
