Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION & IMPORTANT SAFETY INFORMATION
WARNING: Risk of asphyxiation.
WARNING
Use this product only in a well
ventilated area.
24.
small areas or near exhaust fans.
Adequate oxygen is needed for
RISK OF
combustion or dangerous carbon
ASPHYXIATION.
USE THIS PRODUCT
monoxide will result.
ONLY IN A WELL
25.
VENTILATED AREA.
liable for any changes made to
our standard machines or any components not
purchased from us.
26. The best insurance against an accident is
precaution and knowledge of the machine.
27. Do not allow acids, caustic or abrasive fluids to
pass through the pump.
28. Never run pump dry or leave spray gun closed
longer than 1-2 minutes.
29. Machines with shut-off spray gun should not be
operated with the spray gun in the off position
for extensive periods of time as this may cause
damage to the pump.
30. Protect discharge hose from vehicle traffic and
sharp objects. Inspect condition of high pressure
hose before using or bodily injury may result.
31. Before disconnecting discharge hose from water
outlet, open the spray gun and trigger bar to
relieve pressure.
32. Do not overreach or stand on unstable support.
Keep good footing and balance at all times.
33. Do not operate this machine when fatigued
or under the influence of alcohol, prescription
medications, or drugs.
Follow the maintenance instructions
specified in the manual.
GENERAL OPERATING
TECHNIQUES
1.
Turn on water supply and start pressure washer.
2. Pull the trigger for water to start cleaning
surface.
NOTE: Never stop moving the Surface
Cleaner Unit while trigger is engaged and
surface is being sprayed or damage to
surface could occur.
3.
For use of the spray gun in isolated cleaning,
check the nozzle size. The Surface Cleaner Unit
is shipped with a #3 nozzle.
NOTE: For use of the spray gun, be aware that
the Surface Cleaner Unit comes with a #3 nozzle
6
and two #2 nozzles on the rotary swivel.
Avoid installing machines in
Manufacturer will not be
KARCHER Surface Cleaner 9.802-898.0
HIGH PRESSURE
SWIVEL INFORMATION
The Surface Cleaner Unit high pressure swivel will
"weep" water from underneath the cover. This
weeping is normal for this swivel. The swivel uses
water to lubricate its floating seal face to keep wear
down to a minimum.
Also the high pressure swivel is equipped with a
grease fitting and should be greased at least once
every three months. A good quality ball bearing
grease is recom- mended. DO NOT OVER GREASE
THE BEARING!
The Warranty for this high pressure swivel is one
year from date of purchase.
Do not step on this surface.
Turn caster to front in order to active the brake.
Publicidad
