Kärcher 1.107-380.0 Manual Del Usuario página 9

Safety
Latch
High
Pressure Hose
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 1: Check engine oil level. Oil level should be level with the bottom
of the oil filler neck. Be sure the machine is level when checking the oil
level. (Refer to the engine's operating manual included with machine).
We recommend that the oil be changed after the first month or 20 hours
of use, then once every 100 hours or every 6 months after first month.
Note: Improper oil levels will cause low oil sensor to shut off engine.
IMPORTANT! Do not run engine with high or low oil levels as this
will cause engine damage.
Gas
Tank
STEP 3: Fill gas tank with
unleaded gasoline. Do
not use leaded gasoline.
ASSEMBLY INSTRUCTIONS
Cold Water
Spray
Source
Gun
Garden
Hose
STEP 2: Connect garden hose to
the cold water source.
OPERATING INSTRUCTIONS
Oil Dipstick
STEP 4: Connect garden hose
to the cold water source and turn
water on completely. Never use hot
water.
KARCHER Surface Cleaner 9.802-898.0
STEP 3: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Oil Window
STEP 2: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe
oil level in oil window (if equipped).
Use SAE 10W-40 non detergent
oil.
Cold
Water
Source
Garden
Hose
STEP 5: Trigger the spray gun to
eliminate trapped air then wait for
a steady flow of water to emerge
from the spray nozzle.
Pump
Water Inlet
Garden
Hose
Dipstick
9