Tunturi REHA RAILS Manual De Montaje página 13

Before you begin
Thank you for purchasing our Tunturi REHA Rails.
This product is not a complete trainer, but can be
used as an accessory for:
Tunturi T80/ T85 & T90 treadmills of the 2019 &
2022 collection.
We therefore refer to the main product manual for
safety and warranty information as you cannot find
these in this manual.
You can download all Tunturi product manuals on
our website at all times.
Replacing the components does not require
special tools, but assumes a certain level of
technical competence and familiarity with basic
hand tools.
⚠IMPORTANT.
• Before replace the standard handlebar for the
REHA rails be sure that the power has been
switch off and or the mains cable is plugged
off.
Assembly instructions
Description illustration A
The illustration shows what the trainer will looks
like after the assembly is completed.
You can use this as a reference during your
assembly, but do follow the assembly steps
always in the correct sequence as showed in the
illustrations.
Description illustration B
The illustration shows what components and parts
you should find when un-boxing your product.
‼ NOTE
• Small parts can be hidden/ packed in hollow
spaces in the Styrofoam product protection
• If a part is missing, contact your dealer.
Description illustration C
The illustration shows the hardware kit that comes
with your product.
The hardware kit contains bolts, washers, screws
, nuts etc. and the required tools to properly fit
your trainer.
Assembly (fig. D)
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct
assembly of the equipment.
‼ NOTE
• Save the tools provided with this product,
after you completed the product assembly,
for future service purposes.
Additional assembly information
D10 Loosen the upright tubes
Loosen bolts enough to create play, but do not
remove the bolts fully
This is required to fit the REHA rail parts as a
whole.
English
13