Publicidad
Idiomas disponibles
Idiomas disponibles
Remove the blade housing by drawing it towards.
Detach the blade from the blade housing. To connect
the blade, follow the above instructions in reverse order.
Tighten the screws with max. 1.5 Nm. After connecting,
press the grease cup button two to three times.
V
ery shArp BlAde
2.1.3 c
/
Onnecting
detAching the depth gAuge
Position the depth gauge in the blade housing. Secure/
release the depth gauge at the two screws.
Turn the setscrew to set the cutting depth.
2.1.4 c
Dissolve the tension nut with a socket spanner and pull
them out.
Pull the handle and the ring off from the mount.
!
Replace the ring with the thumb rest. There are different
possible positions available. Push the handle in the de-
sired position on the carrier. Screw the tension nut with a
socket spanner and tighten them.
2.2 r
Blade diameter
Maximum speed
Vibration
Weight
ment of the exposure.
/
Onnecting
detAching the thumB rest
Ating dAtA
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
131mm
-1
4500min
2
≤2.5m/s
500g
27
Publicidad
