Cleaning The Nozzle - Gaggenau CM 210 Manual De Instrucciones

Cleaning the nozzle

Clean the nozzle after each use.
Place a suitable receptacle under the nozzle.
Briefly set function selector to 0.
m
Avoid the risk of scalding!
When the function selector is set to 0, the nozzle may
spurt slightly. Escaping water is very hot.
Do not touch nozzle or direct at people!
Set function selector to ) position.
Wipe the outside of the nozzle after it has cooled
down.
Dismantle the nozzle to clean thoroughly.
Proceed as follows:
Unscrew the nozzle with a coin.
In particular, clean the tip of the nozzle with a brush
and pointed implement.
Clean all parts with hot water and detergent, rinse
and dry (dishwasher-safe).
CAUTION
WARNING
m
29