Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Extra Rinse
After set the function of Extra Rinse, the program runs the rinsing process once again before
running the softening, and the total running time of the program increases accordingly.
Time Save
After pressing this function button, the program time will be shortened according to the setting,
and the program time will be increased back to the original setting by pressing the Time Save
button again. After the program starts, the indicator ligbt is always on.
This function is only added under the standby state of its applicable program, that is, before
the program is started. After the program is started, the function cannot be selected.
After this function is selected, the determined main washing time will be reduced by 15 mins.
Inlet water warning
If tap is not opened, or water pressure is over low, inlet water fault icon will display, and display
screen will prompt «F01» to give alarm.
Drainage warning
If the pipe is squeezed, drainage will not be smooth. In case of failing to completely drain for
long time, drainage fault icon will display, and display screen will prompt «F03» to give alarm.
Door Lock Icon
After the program starts the Door Lock icon will light up and the door will be locked.
After completing program, door lock unlocks automatically. During pause, if door opening
condition can be met halfway, the door lock will unlock and its indicator light will go out.
When door lock indicator light flashes, door shall not be opened forcibly so as to avoid personal
injury.
Delay End Function
Delay End function allows to run the machine at the consumers' convenience, for example,
at night when electricity is cheaper.
•
Only under the standby mode, this button is valid for selecting the reservation time.
•
After the reservation function is selected, the time will increase 1h when each time the
reservation button is pressed. Before reservation, if the program time does not satisfy the
integral multiple of 1h, it shall be completed by pressing the reservation key for the first
time, and then the time increases 1h when each time the reservation button is pressed.
If the reservation is selected, before the program runs, the current reservation can be
canceled by turning the button to select other programs.
•
The delay time must be longer than the wash program length as the delay time is the
time program will finish. For example: if the selected program time is 02:28, the delay
time selected must be between 03:00 and 24:00.
•
When the reservation process is operated, the icon of 'reservation time' will be on. When
the reservation process startup, the icon of 'reservation time' will flash.
•
Long press the Delay End button, the reservation time jumps fast.
20
EN
Publicidad
