Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Problem
Final spin results are poor.
If your washing machine
has a time display: the
programme time initially
displayed is lengthened /
shortened by a period of
time:
Enter the after-sales query mode
1.
In the OFF mode, press the "Detergent" + "Spin" + " " to enter the after-sales inquiry mode.
2.
It displays the number of operation cycles.
3.
Press "Spin" to switch cycles or fault codes.
4.
When querying fault codes, press the "Detergent" to page up and the "Temp." to page down.
For Models with Single Inlet
1.
Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the
machine as (Fig.1).
Check whether / Possible cause
The washing machine has an imbalance detection and
correction system. If individual heavy items are loaded
(e.g. bathrobes), this system may reduce the spin speed
automatically or even interrupt the spin completely if it
detects too great an imbalance even after several spin
starts, in order to protect the washing machine.
• If the laundry is still too wet at the end of the cycle,
remove some articles of laundry and repeat the spin
cycle.
• Excessive foam formation may prevent spinning. Use
the correct amount of detergent.
• Check that the spin speed selector has not been set
to "0".
This is a normal capacity of the washing machine to
adapt to factors that can have an effect on the wash
programme time, e.g.:
• Excess foam formation;
• Load imbalance due to heavy items of laundry;
• Prolonged heating time due to reduced inlet water
temperature;
Because of influences like these, the time remaining
in the programme run is recalculated, and updated
if necessary. In addition, during the filling phase,
the washing machine determines the load and if
necessary adjusts the initial programme time displayed
accordingly. During such update periods, an animation
appears on the time display.
29
EN
Publicidad
