Publicidad
Idiomas disponibles
Idiomas disponibles
maintenance:
•
Saw cuts to one side or at an angle.
•
Saw has to be forced through the cut.
•
Inadequate supply of oil to the bar and chain.
Check the condition of the Guide Bar each time the chain
is sharpened. A worn Guide Bar will damage the chain
and make cutting difficult.
After each use, remove the battery pack, clean all
sawdust from the Guide Bar and sprocket hole.
When rail top is uneven, use a flat file to restore square
edges and sides.
File Rail Edges and
Sides
Square
Worn Groove
Replace the Guide Bar when the groove is worn, the
Guide Bar is bent or cracked, or when excess heating or
burring of the rails occurs. If replacement is necessary,
use only the Guide Bar specified for your saw in the repair
parts list or on the decal located on the pruning saw.
Replacing Bar & Chain
Replace chain when cutters are too worn to sharpen or
when chain stops. Only use replacement chain noted in
this manual.
Inspect Guide Bar before sharpening chain. A worn or
damaged Guide Bar is unsafe. A worn or damaged Guide
Bar will damage chain. It will also make cutting harder.
SHARPENING SAW CHAIN
WARNING:
Remove the battery pack before servicing.
Severe injury or death could occur from electrical
shock or body contact with moving chain.
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Keep chain sharp. Your saw will cut faster and more
safely. A dull chain will cause undue sprocket, Guide Bar,
chain, and motor wear. If you must force chain into wood
and cutting creates only sawdust with few large chips,
chain is dull.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
o
of tool and battery is 0
C-45
The recommended ambient temperature range for the
charging system during charging is 0
104 °F).
TROUBLESHOOTING TABLE
The following table gives checks and actions that you
can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact
your service agent.
Cordless Pruning Saw
Correct Groove
o
C (32 °F - 113 °F).
o
o
C-40
C (32 °F -
WARNING: Switch off and remove the battery pack
before investigating fault.
Symptom
Possible Cause
Chainsaw
Out of battery.
fails to
operate
Fuse faulty.
Over heating
Applying too
much pressure
Chainsaw
while cutting.
operates
intermittently
Loose
connection.
Internal wiring
defective.
On/off switch
defective.
Chain is over
tensioned
Chain/chain
bar over-heats
Dull chain
Chain tension too
loose
Dull chain
Chainsaw rips,
vibrates,
Chain worn out
does not saw
properly
Chain teeth are
facing in the
wrong
direction
Remedy
Charge the
battery pack.
Replace fuse.
Place the
machine in a cool,
ventilated place to
cool it down
Applying
relatively less
pressure while
cutting
Contact service
agent 1-866-354-
Worx (9679).
Adjust chain
tension
Sharpen chain or
replace
Adjust chain
tension
19
Sharpen chain or
replace
Replace chain
Reassemble with
chain in correct
direction
EN
Publicidad
