Publicidad
Idiomas disponibles
Idiomas disponibles
designed for use with the equipment.
i) Keep battery pack out of the reach of children.
j) Seek medical advice immediately if a cell or
battery has been swallowed.
k) Always purchase the battery pack
recommended by the device manufacturer for
the equipment.
l) Keep battery pack clean and dry.
m) Wipe the battery pack terminals with a clean
dry cloth if they become dirty.
n) Battery pack needs to be charged before use.
Always use the correct charger and refer to
the manufacturer's instructions or equipment
manual for proper charging instructions.
o) Do not leave battery pack on prolonged charge
when not in use.
p) After extended periods of storage, it may
be necessary to charge and discharge the
battery pack several times to obtain maximum
performance.
q) Recharge only with the charger specified
by Worx. Do not use any charger other than
that specifically provided for use with the
equipment.
r) Retain the original product literature for future
reference.
s) Use only the battery pack in the application for
which it was intended.
t) Remove the battery pack from the equipment
when not in use.
u) Dispose of properly.
v) Do not mix cells of different manufacture,
capacity, size or type within a device.
6
SAVE THESE INSTRUCTIONS
Instructions concerning the proper techniques for
limbing and cross-cutting
1. Limbing a tree
Limbing is removing the branches from a fallen tree.
When limbing leave larger lower limbs to support the
log off the ground. Remove the small limbs in one cut as
illustrated in Figure 1. Branches under tension should be
cut from the bottom up to avoid binding the pruning saw.
2. Bucking a log
Bucking is cutting a log into lengths. It is important to
make sure your footing is firm and your weight is evenly
distributed on both feet. When possible, the log should
be raised and supported by the use of limbs, logs or
chocks. Follow the simple directions for easy cutting.
When the log is supported along its entire length as
illustrated in Figure 2, it is cut from the top (overbuck),
avoid contacting ground as this will greatly reduce the
Cordless Pruning Saw
Figure 1
chain sharpness.
Figure 2
When the log is supported on one end, as illustrated
in Figure 3, cut 1/3 the diameter from the underside
( underbuck) (1). Then make the finished cut by
overbucking (2) to meet the first cut.
1
1/3
Figure 3
When the log is supported on both ends, as illustrated
in Figure 4, cut 1/3 the diameter from the top (overbuck)
(1). Then make the finished cut by underbucking (2) the
lower 2/3 to meet the first cut.
1
1/3
Figure 4
When bucking on a slope always stand on the uphill
side of the log, as illustrated in Figure 5. When "cutting
through", to maintain complete control release the
2
2/3
2
2/3
EN
Publicidad
