Door Open/Close Adjustment; Programming And Adjustment Of The Control Board; Potentiometer Adjustment - Erreka ZEUS T1500 Manual Del Instalador

INSTALLING AND PROGRAMMING
7

DOOR OPEN/CLOSE ADJUSTMENT

8

PROGRAMMING AND ADJUSTMENT OF THE CONTROL BOARD

Potentiometer adjustment

PM
Torque adjustment (limits the maximum thrust)

Correct torque
importance to prevent injury and damage.
Greater torque produces a more violent impact.
Set PM at the minimum value possible,
compatible with the proper operation of the
door.
T.E.
Standby time regulation (only works in
automatic mode). If automatic functioning mode
has been programmed (DIP2=ON), adjust T.E. to
set standby time with the door open (before
automatic closing begins).
T.M. Operation time adjustment (operator
functioning time). The operation time should be
sufficient for the entire opening/closing (the limit
switches must be reached).
46
Installation Guide
adjustment is of vital

Before carrying out any door movement,
ensure there is no person or object in the radius
of action of the door and the operation
mechanisms.
1 Adjust the camshaft (1) to regulate the closing
position of the door.
2 Adjust the camshaft (2) to regulate the opening
position of the door.
Programming DIPs (SW1)
DIP1: startup impulse

DIP1=ON: startup impulse activated (the
thrust of the operator during the start of operations
is greater in order to allow improved startup).

DIP1=OFF: startup impulse disabled.
DIP2: closing mode

DIP2=ON: automatic mode (the door closes
automatically after standby time).

DIP2=OFF: semi-automatic mode (the door
only closes when receiving an operation command).

Standby time is adjusted by way of T.E.
DIP3: close impulse

DIP3=ON: close impulse activated (the thrust
of the operator increases at the end of slowdown
during closing).

DIP3=OFF: closing impulse disabled.
DIP4: advance warning

DIP4=ON: the light comes on and operation
begins after a 2 second warning.

DIP4=OFF: the light comes on and operation
begins immediately.