Operation Modes; Obstacle Detection Functioning; Declaration Of Conformity - Erreka ZEUS T1500 Manual Del Instalador

DESCRIPTION OF THE PRODUCT
5

OPERATION MODES

Automatic mode (DIP2=ON)
Opening: this begins by activating the key command
(magnetic key, key switch, etc).

Opening is carried out step-by-step: the door
halts if a key command is activated. The door closes
when operated again.
S t a n d b y : t h e d o o r r e m a i n s o p e n d u r i n g t h e
programmed time.
• If, during standby, the safety device is activated,
standby time starts again.
• If, during standby, the key command is activated,
the door closes.
Semi-automatic mode (DIP2=OFF)
Opening: this begins by activating the key command
(magnetic key, key switch, etc).

Opening is carried out step-by-step: the door
halts if a key command is activated. The door closes
if operated again.
Standby: the door remains open until the key
command is operated.
6

OBSTACLE DETECTION FUNCTIONING

The door can detect an obstacle in two ways:
A- Detection by photocell or mechanical
strip (S.G)
The safety device only operates during closing, in other
words:
• if, during opening, the safety device is activated,
the door continues to open
• if, during closing, the safety device is activated, the
door inverts operation direction and opens
completely
7

DECLARATION OF CONFORMITY

Erreka Automatismos declares that the ZEUS operator
has been designed for use in a machine or for assembly
along with other elements in order to form a machine
in line with Directive 89/392 EEC and successive
modifications.
38
Installation Guide
Close: at the end of standby time (or when using the
key command), the closing operation begins.

If, during closing, the key command is activated, the
door inverts operation direction and opens
completely.
Close: the closing process starts up by using the key
command.

If, during closing, the key command is activated, the
door inverts operation direction and opens
completely.
B- Direct detection (built-in safety)
During opening and closing: the operator has an
electronic thrust limiter, which can be adjusted using
PM (see "Fig. 3 Control board connections and
components" on page 45). If the door comes across an
obstacle, the thrust limiter comes into operation,
meaning the door will continue to push but with a
limited thrust.

With the LTT15 SENS anti-crush sensor installed
(optional), if the door comes across an obstacle
during closing, it inverts operation and opens.

It is essential to correctly adjust the maximum
thrust when first starting up the facility.
The ZEUS operator complies with safety legislation in
line with the following directives and standards:
• 73/23 EEC and successive modification 93/68 EEC
• 89/366 EEC and successive modifications 92/31 EEC
and 93/68 EEC
• UNE-EN 60335-1